Posted by admin on 07/12/08 in Uncategorized
1. use your blade or sharp equipment to slot a hatch on the surface of pop can near one end.
2.cut of the upper and bottom surface of can with your scissor.
3.cut vertical opening on the bottomless can, so it becomes to be a unfolded metal slice.
4. turn the inside out, and draw a rectangle with width 5.5 centimeter and length 12.5 centimeter with mark pen.
5.then draw a curve on each corner of it.
6.cut the drawing off.
7.place the can slice on a prepared paper board, and draw a similar shape on the board.
This is a preview of
An easiest way to make a Naruto forehead guard
.
Read the full post (398 words, estimated 1:36 mins reading time)Share This
tag this | permalink | trackback url | comments(0)
Posted by admin on 07/11/08 in Uncategorized
1. use your blade or sharp equipment to slot a hatch on the surface of pop can near one end.
2.cut of the upper and bottom surface of can with your scissor.
3.cut vertical opening on the bottomless can, so it becomes to be a unfolded metal slice.
4. turn the inside out, and draw a rectangle with width 5.5 centimeter and length 12.5 centimeter with mark pen.
5.then draw a curve on each corner of it.
6.cut the drawing off.
7.place the can slice on a prepared paper board, and draw a similar shape on the board.
This is a preview of
An easiest way to make a Naruto forehead guard
.
Read the full post (398 words, estimated 1:36 mins reading time)Share This
tag this | permalink | trackback url | comments(0)